I purchased a few replacement fans and they come without the connectors attached. I ordered a few different connectors from Digikey thinking they were the right size but apparently I have no clue what I'm looking for.
Any direction on the connectors I need to purchase to get these fans to work?
Thanks
Connectors for replacement switch fans?
- Airfibber
- Member
- Posts: 1
- Joined: Mon Aug 12, 2024 12:02 pm
- Has thanked: 0 time
- Been thanked: 0 time
-
sirhc - Employee
- Posts: 7414
- Joined: Tue Apr 08, 2014 3:48 pm
- Location: Lancaster, PA
- Has thanked: 1608 times
- Been thanked: 1325 times
Re: Connectors for replacement switch fans?
We sell replacement fans and they come with ends properly wired. If you wire them up wrong you can fry your board or at minimum the fan circuit.
Just any fan won't always work as we use pulses to control fan speeds.
If your replacing a fan with a third party fan you can always use the end from the old fan.
Red is +
Black is -
Yellow is the sensor in the fan for RPM
Just any fan won't always work as we use pulses to control fan speeds.
If your replacing a fan with a third party fan you can always use the end from the old fan.
Red is +
Black is -
Yellow is the sensor in the fan for RPM
Support is handled on the Forums not in Emails and PMs.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
2 posts
Page 1 of 1
Who is online
Users browsing this forum: No registered users and 9 guests