Feature Request - turn off poe based on voltage and time

[commy]

Hi,

Apologies if this not the proper place to post this request.
It is great to have such a good switch that can turn off the PoE at specific voltage and times - is it possible to provide an option that first checks if the voltage is below a predefined value and then consider the shutdown timers. This is required in the event that you have a solar site with 2 days no sunlight and the banks are getting low, to give the ability to start turning off ports based on time when it hits that lower voltage levels as a first measure.

Thank you

[sirhc]

This is already supported.

With the SMART DC switches (WS-8-150-DC - WS-12-250-DC - WS-26-500-DC)

LOOK ON THE POWER TAB

On all switches you can turn off and on POE based on time condition also on the Power TAB.

viewtopic.php?f=17&t=3415&p=22421&hilit=+power+voltage#p22421


Also make sure your running v1.4.9 firmware

[commy]

Hi,

Yes, but when we fill in the time condition - it always takes effect regardless of the voltage. We would like a toggle that makes it able to first check the voltage and then take into consideration the time ranges.

[cbwecomm]

This would be a handy feature, for the same use case.