TX / RX Limit - Bug or misunderstanding?

[mhoppes]

Whenever I type a value into the TX and RX limit fields for a switch port, the box turns red and then I get an error "Invalid Fields". What's up with that?

Screen Shot 2014-12-12 at 3.43.56 PM.png (17.28 KiB) Viewed 5820 times

Screen Shot 2014-12-12 at 3.43.47 PM.png (16 KiB) Viewed 5820 times

[sirhc]

You are NOT following the instruction provided on the UI Matt?

As you can CLEARLY see in the mouse over it shows you EXAMPLES. (see image below)
CLICK IMAGE TO SEE FULL SIZE

Mouse over instructions.png (113.26 KiB) Viewed 5816 times

Since the field can clearly support speed or packet limiting it needs to know what you want. (see image below)
CLICK IMAGE TO SEE FULL SIZE

duh.png (110.62 KiB) Viewed 5816 times

Valid inputs would be:
512kbps
10mbps
100mbos

1000pps
5000pps

[mhoppes]

I did not get the mouse over... didn't we talk about this when I was down there? :)

[mhoppes]

Well that did it.... thanks... apparently in my haste to configure while standing in the cold I clicked in the box and didn't hover long enough :) I thought that hover thing was fixed ages ago.

[mhoppes]

Now... what if I want to limit PPS AND Throughput??? :)

[sirhc]

Now... what if I want to limit PPS AND Throughput??? :)

It is a limitation of the switch core not our UI, it's one or the other.

Maybe in the future we will build a higher end switch based on a more expensive core, possibly Layer 4 that allows more ability.

But first we NEED to sell these, a LOT more of "these" to raise capital to build the MINI and DC versions of these.

[mhoppes]

I expect to be buying two more very soon :)

[rockhead]

I see they are now available at ubnt.ca so I'll be purchasing through the distributor to keep them buying too !