CLI Commands
- SYS7EM-Kris
- Member
- Posts: 3
- Joined: Sun Dec 18, 2016 12:25 pm
- Has thanked: 0 time
- Been thanked: 0 time
CLI Commands
Anyone know where I can get a list of CLI Commands for Netonix switches running 1.4.6 firmware? I am trying to figure out how to do a rapid ping
-
sirhc - Employee
- Posts: 7437
- Joined: Tue Apr 08, 2014 3:48 pm
- Location: Lancaster, PA
- Has thanked: 1613 times
- Been thanked: 1328 times
Re: CLI Commands
SIMPLY hit "?" and press enter it provides a list of commands available where you are just like a Cisco router
If you type a partial command followed by a "?" and press enter it shows how to complete the command
If you can not follow the bouncing ball in the CLI to get help I am not sure how a printed list would help.
This way the help is always 2 keystrokes away.
If you type a partial command followed by a "?" and press enter it shows how to complete the command
If you can not follow the bouncing ball in the CLI to get help I am not sure how a printed list would help.
This way the help is always 2 keystrokes away.
Support is handled on the Forums not in Emails and PMs.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
- SYS7EM-Kris
- Member
- Posts: 3
- Joined: Sun Dec 18, 2016 12:25 pm
- Has thanked: 0 time
- Been thanked: 0 time
Re: CLI Commands
Got it. Thanks. I was going to try the question mark like Cisco and Juniper I just have not been in the CLI of a Netonix and my guys are in the field getting one installed on our back bone so I wanted to see if I could find out how to do it before hand.
Re: CLI Commands
First go at the CLI and tbh the help wasn't a lot of use. Once you're done in configure mode, how do you write the config? Not in the help. So what do I do? I "end" to get out of config mode - and this triggers the save.
Netonix can you hire someone please to spend a few days on basic documentation?
Netonix can you hire someone please to spend a few days on basic documentation?
4 posts
Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests