The reset-configuration-changes on the UI is FAR too aggressive.
I've had several occasions which my phone rang or something, causing the switch to reboot because I didn't click "save"; or the fact that it's impossible to change the IP address to something unreachable.
For example, I'm setting up a switch in the office to take to the site. I assign the IP address for the permanent installation. The switch will now reboot because the IP isn't reachable on the local subnet.
Sure, there are ways around it; but it's just annoying.
There should be some mechanism to bypass this test and simply unconditionally apply.
Product Feedback
-
sirhc - Employee
- Posts: 7415
- Joined: Tue Apr 08, 2014 3:48 pm
- Location: Lancaster, PA
- Has thanked: 1608 times
- Been thanked: 1325 times
Re: Product Feedback
There is, simply disable Revert Timer to 0
viewtopic.php?f=6&t=1258&p=15961&hilit=+revert+timer+0#p15963
viewtopic.php?f=6&t=1258&p=15961&hilit=+revert+timer+0#p15963
Support is handled on the Forums not in Emails and PMs.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
2 posts
Page 1 of 1
Who is online
Users browsing this forum: No registered users and 16 guests