LibreNMS Netonix Support Updated

[tonym]

LibreNMS was just updated to include DC power input and Total Power usage. We also get detailed STP information now that WispSwitch supports BRIDGE-MIB. I hope they add LLDP-MIB next :)

[mlow]

It would be lovely if there was a OID for total power consumption

Then I could have a calculated item in zabbix for estimated battery time remaining .. :)

[Eric Stern]

Its already there. 1.3.6.1.4.1.46242.6

[mlow]

Oh, new MIB! Thanks.

[shaunm]

Ok so I'm just learning how to do this but when I add a netonix device to libre I don't get any of the above? does Libre not poll the device ?

[scracha]

Works like a charm....thanks

[tonym]

Ok so I'm just learning how to do this but when I add a netonix device to libre I don't get any of the above? does Libre not poll the device ?

It automatically adds all of that, perhaps your install was not up to date?

[jjonsson]

What about this issue:
https://github.com/librenms/librenms/issues/6663 ?

[tonym]

It is as described in the ticket. Netonix does not fully support Q-BRIDGE-MIB, they only implemented some of the required fields and some incorrectly.

They seem to have a habit of only partially implementing standard MIBs. They are aware of the issue and hopefully get it it fixed next release.

[scracha]

Overall consumption is useful but is it possible for LibreNMS to obtain individual wattage / consumption per POE port? With solar sites it'd be really good to have stats on what a radio uses over a 24 hour period etc.