Issue with WS-12-250X using port 13&14 in VLANS

[sirhc]

This is your second post on the same issue.

Yep, because I didn't want two different problems getting wrapped up with this one.

The problem of NOT turning PoE Ports OFF when doing a factory default has been fixed with v1.0.6rc3

[adairw]

I feel like all my posts are getting doubled up and crossing paths. that's why I keep trying to post the relevant info on the proper toppic but I'm figuring out things while searching for others.

As I mentioned in my " Copper SFP" thread, VLAN's on Copper SFP ports in 13 & 14 are working after a hard reboot/power cycle.

I made no other config changes but to reboot the switch...well I had swapped the SFP's right after the reboot. but I don't think that mattered. I swapped them back and they still work.
As previously stated, this is the first time I've had the switch down since putting in the rack a few weeks ago. been through 4-5 software upgrades and several soft/gui reboots since that time.

So, all is well with the world right now re vlans and sfp's.