Export power measurements via SNMP (WS-12-DC) ?
Posted: Fri Aug 28, 2015 2:12 pm
I'm not sure if this is different with the DC-250 models, but the WS-12-DC does not seem to report the input voltage via SNMP.
(it's readable in the status page).
Running a quick snmpwalk (2c) against model WS-12-DC (not 250), does not seem to expose the voltage to the main board...
Am I overlooking it, or it does not exist?
Would be VERY nice to have...
I presume it does exist for the 250 models?
(it's readable in the status page).
Running a quick snmpwalk (2c) against model WS-12-DC (not 250), does not seem to expose the voltage to the main board...
Am I overlooking it, or it does not exist?
Would be VERY nice to have...
I presume it does exist for the 250 models?