Hang upon hostname change from CMDline
Posted: Wed May 27, 2015 12:11 am
Been remotely configuring a switch in the field using command line...
This command got the switch to hang (equipment remain powered, but no ping):
Will try to drive out there tomorrow to reboot ;-(
(latest stable firmware - don't recall from memory what is the version number).
This command got the switch to hang (equipment remain powered, but no ping):
- Code: Select all
Netonix Switch(config)# hostname Cory-Netonix-SW
Will try to drive out there tomorrow to reboot ;-(
(latest stable firmware - don't recall from memory what is the version number).