Page 1 of 2
WS-6-MINI Barrel plug
Posted: Thu May 07, 2015 8:36 pm
by ryanm
What size barrel plug is needed to fit the mini?
Thanks!
Re: WS-6-MINI Barrel plug
Posted: Fri May 08, 2015 7:59 am
by Dave
2.5mm center pin
Re: WS-6-MINI Barrel plug
Posted: Fri May 08, 2015 8:35 am
by ryanm
Re: WS-6-MINI Barrel plug
Posted: Fri May 08, 2015 2:12 pm
by Dave
Below link is actual connector on the board. Digikey has the mating connector as "2.5mm ID, 5.5mm OD"
http://www.cui.com/product/resource/pj-002bh-smt.pdf
Re: WS-6-MINI Barrel plug
Posted: Fri May 08, 2015 2:59 pm
by ryanm
That makes it easy! Thanks, Dave!
I hadn't gotten to assemble the crazy DIN connectors that the tycon hi-power injector needs, so I was hoping I'd have a barrel plug to fit. Apparently that is a 'no', but now I know what I need.
Re: WS-6-MINI Barrel plug
Posted: Fri May 08, 2015 3:41 pm
by wayneorack
I am hoping that it is the same as the PS that comes with Cisco phones. I have boxes of those.
Re: WS-6-MINI Barrel plug
Posted: Fri May 08, 2015 3:56 pm
by ryanm
wayneorack: let us know when you figure it out. It's always good to know.
I MIGHT even have one of those floating around somewhere.
Re: WS-6-MINI Barrel plug
Posted: Fri May 08, 2015 4:44 pm
by wayneorack
UPS tracking says my MINI will be here Tuesday. I'll let yo know then.
Re: WS-6-MINI Barrel plug
Posted: Fri May 08, 2015 7:32 pm
by lligetfa
Looks like mine is locked up at the Post Office in town and I won't be able to get it before Monday.
Re: WS-6-MINI Barrel plug
Posted: Fri May 08, 2015 7:39 pm
by sirhc
lligetfa wrote:Looks like mine is locked up at the Post Office in town and I won't be able to get it before Monday.
Yea but your old one works fine for now!