Page 1 of 1
Traffic Throughput in bits/s
Posted: Sun Feb 24, 2019 1:14 pm
by zgould
I was curious to know if there is a possibility that an 'option' can be implemented to allow us to see our traffic throughput in MegaBITS rather than MegaBYTES.
It would really save me a lot of math time to not have to calculate down to bits/s to measure my actual throughput.
Thank you!
Re: Traffic Throughput in bits/s
Posted: Mon Feb 25, 2019 9:26 am
by jakematic
In the Netonix Manager ?
The switches have always shown bits, but the Manager has always shown bytes.
viewtopic.php?f=6&t=1549&start=190#p22767
Re: Traffic Throughput in bits/s
Posted: Mon Feb 25, 2019 12:03 pm
by zgould
I'm not sure what Netonix Manager is -- I am logged into the IP of the switch.
It shows all the reading as "MB" which refers to MegaBytes, as opposed to "Mb" which refers to bits. This could be a typo on the GUI if it indeed refers to bits; I'm just not sure & I'm assuming.
Does it refer to bits?
Thanks!
Re: Traffic Throughput in bits/s
Posted: Mon Feb 25, 2019 12:18 pm
by sirhc
So on the main Status TAB as shown below in screen grab:
The upper right corner stats can change based on the size of the number as there is limited space.
In example Mbps (Bits) or Kbps (Bits) and I think MBps (Bytes) in some conditions.
The graph below is in Mbps (Bits), I am not sure it changes to MBps (Bytes).
CLICK IMAGE BELOW TO VIEW FULL SIZE
Re: Traffic Throughput in bits/s
Posted: Mon Feb 25, 2019 1:05 pm
by zgould
Oh yeah - I see it now in the graphs. Duh.
Thank you!