Netonix Forums

Since upgrading to firmware 1.1.0rc15 I have been unable to reach devices on my primary switch. This did not occur on earlier firmware.

Quick overview of my setup:
HP ProCurve 1810G-24 -> WS-12-250B -> UniFi WAP's

I have no vlans configured on either switch. I can access devices connected on the Netonix switch from the Procurve switch.

overkill wrote:Since upgrading to firmware 1.1.0rc15 I have been unable to reach devices on my primary switch. This did not occur on earlier firmware.

Quick overview of my setup:
HP ProCurve 1810G-24 -> WS-12-250B -> UniFi WAP's

I have no vlans configured on either switch. I can access devices connected on the Netonix switch from the Procurve switch.

OK so I am guessing what your calling your "primary" switch is the HP pro curve?

When you say you can not access devices connected to your "primary"/HP Procurve switch which switch are you connected to that you can not access devices on the HP Procurve but can on the Netonix Switch?

Are you connecting to the Procurve but can not see devices also connected to the Procurve?

I would love to help but your not very specific?

User error. Android phone couldn't connect until reboot of the phone.


Sorry.