Netonix Forums

Radius Authentication

Good day

I have a ws-12-dc firmware 1.4.9.
I would like to use radius for authentication to log into the switch.
Is this possible on this device?

I am using Freeradius and it gives me the following error when I try to auth.
Ignoring request to authentication address * port 1812 from unknown client 192.168.0.12 port 44075.

Thank you in advance.

If you go to the DEVICE/CONFIGURATION TAB and scroll down you will see a place to configure Radius authentication.

Hi Sirhc

That is where I did the config.
But I get the following error on the radius server: Ignoring request to authentication address * port 1812 from unknown client 192.168.0.12 port 44075.
I know the radius server is working my Mikrotik devices are authenticating.

Regards,

h8r1dx4 wrote:Ignoring request to authentication address * port 1812 from unknown client 192.168.0.12 port 44075.
I know the radius server is working my Mikrotik devices are authenticating.

This would suggest that the switch is not defined in /etc/freeradius/clients.conf

I use a mysql database and the device is defined in the nas table. Just like the working Mikrotik devices.