Netonix Forums

Hi:

Is the MSTP ready? It has already been tested by someone?

Thank You.

From my test, per port cost and priority don't work. The switch will beavior like RSTP for every instance.

P.S.: Eric, I'm have waiting for fix to test for the last 4 month if I remember well.

This was fixed in 1.4.8rc10.

Fixed problem with MSTP setting priority and path cost - RC10

I didn't saw it. I'll will try it out soon
Thanks

Hi:

I'm going to test MSPT at laboratory before configure at my land.
If possible, attach me some pictures of your switchess and your scenery.

Thanks.

3 netonix in ring. I'm looking if I can change root path beharvior but from my test, MSTP priority don't work so it beavior just like RSTP.
viewtopic.php?f=17&t=2747&start=60

I just finish to test MSTP on my laboratory. It seems to work fine. Now I going to implement it at my real scenery. I will send my reports.

Have you try priority on MST instance ? If so, did you use Netonix as root switch ?

Hi:

I'll try to explain it with my poor English.

My scenery is a ring with 3 netonix.

1.- Root Switch (Swtch A)

Select CIST option. Name and Revision must be the same in all switches.. Root Switch priority must be lower ej: 28672
Select Ports enable then must connect with others switches.
Finish

2.- Switch B and C

Select CIST option. Name and Revision equal than Root Bridge. (Ej: Name:test Revision: 10), and check enable ports.
Select MIST instance 1. Write Vlan list. (Vlans is use in each switch)
Select MIST instance 2. Write Vlan list. (Vlans in standby)

Finish.

Advice: don't forget set trunks with all vlans in all switches...

in case to use a utiquiti link put configuration simple, and select vlan manage (put Vlan ID inside box)

If you have any problem i can send you screen shots.

Now i going to test with 4 switch... i'll report test.

Have you tryed to have a different master bridge than the root bridge of CIST on instance 1 ?

Have you try to make the traffic pass via an other uplink for instance 1 ?