Product Feedback
Posted: Fri Dec 09, 2016 7:29 pm
The reset-configuration-changes on the UI is FAR too aggressive.
I've had several occasions which my phone rang or something, causing the switch to reboot because I didn't click "save"; or the fact that it's impossible to change the IP address to something unreachable.
For example, I'm setting up a switch in the office to take to the site. I assign the IP address for the permanent installation. The switch will now reboot because the IP isn't reachable on the local subnet.
Sure, there are ways around it; but it's just annoying.
There should be some mechanism to bypass this test and simply unconditionally apply.
I've had several occasions which my phone rang or something, causing the switch to reboot because I didn't click "save"; or the fact that it's impossible to change the IP address to something unreachable.
For example, I'm setting up a switch in the office to take to the site. I assign the IP address for the permanent installation. The switch will now reboot because the IP isn't reachable on the local subnet.
Sure, there are ways around it; but it's just annoying.
There should be some mechanism to bypass this test and simply unconditionally apply.