Page 1 of 1
Clear counters?
Posted: Sat Apr 02, 2016 3:35 pm
by sporkman
In the Cisco world, I have gotten used to troubleshooting cable issues by clearing all the counters on the port and then watching for any errors to increment. Yesterday a ws-8-250 started showing errors on one port. Today someone went out to re-crimp the cable which seems to have resolved things.
Question - I'm not seeing a way to clear the counters on a port (or all ports). Am I blind or does this not exist? Firmware 1.3.8.
Re: Clear counters?
Posted: Sat Apr 02, 2016 3:47 pm
by sirhc
You are blind for sure.
Click on gear at top of list to clear all port counters.
Click on gear end of each port row to clear single port counters (needs v1.3.9 for this feature).
Also you need to upgrade to version 1.3.9
Re: Clear counters?
Posted: Sat Apr 02, 2016 4:19 pm
by sporkman
I was close, I was looking at the gear on the end of the row. Totally didn't see the gear at the top though... :)
1.3.9 comes in the dead of the night, don't want to disrupt these people further.
While I'm here, anyone have strong feelings about the sub-$1000 cable tester market? I think this guy is working with an old continuity-only tester.
Re: Clear counters?
Posted: Sat Apr 02, 2016 5:15 pm
by sirhc
sporkman wrote:I was close, I was looking at the gear on the end of the row. Totally didn't see the gear at the top though... :)
1.3.9 comes in the dead of the night, don't want to disrupt these people further.
While I'm here, anyone have strong feelings about the sub-$1000 cable tester market? I think this guy is working with an old continuity-only tester.
Here is our manager software so you can schedule upgrades
viewtopic.php?f=6&t=1549