Fried ports....
Posted: Sun Dec 06, 2015 6:49 pm
I had a bad drum of UBNT TOUGHcable Carrier I used for a mast. Unfortunately something was wrong with the cable. I had 8 cables up the mast and all sucks water like a sponge.
My enclosure was filled with water. 2 of the cables was in use. 2 ports on my WS-12-250-AC switch is fried....
I'm not sure about the Rocket M5 and AF-5 at the other end of the cable. Hasn't tested them yet....
Anything I can do myself ? Can I clean the ports and test them ? Or do I just calculate with the switch being dead ?
I can accept using the switch at home as test switch. If the 2 ports are dead I'll cover them...
My enclosure was filled with water. 2 of the cables was in use. 2 ports on my WS-12-250-AC switch is fried....
I'm not sure about the Rocket M5 and AF-5 at the other end of the cable. Hasn't tested them yet....
Anything I can do myself ? Can I clean the ports and test them ? Or do I just calculate with the switch being dead ?- IMG_20151206_232550.jpg (451.54 KiB) Viewed 4839 times
I can accept using the switch at home as test switch. If the 2 ports are dead I'll cover them...