If I have a Ubiquiti EdgeRouter connected to a Netonix switch can I enable LACP in such a fashion that it will only use one interface, unless that interface stops passing traffic and then it will use the other one? I don't want both used at the same time.
Scenario is:
Router--->Traffic Shaper--->Switch
In the event the traffic shaper stops passing traffic I want traffic to bypass it and continue. If I can't figure out a way to do it on switching fabric, the next step is to just put a second router after the traffic shaper and run OSPF, but that seems like overkill.
LAG Question
-
sirhc - Employee
- Posts: 7415
- Joined: Tue Apr 08, 2014 3:48 pm
- Location: Lancaster, PA
- Has thanked: 1608 times
- Been thanked: 1325 times
Re: LAG Question
You want RSTP not LAG
Support is handled on the Forums not in Emails and PMs.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
-
mhoppes - Associate
- Posts: 664
- Joined: Thu Apr 10, 2014 9:14 pm
- Location: Pennsylvania
- Has thanked: 10 times
- Been thanked: 125 times
Re: LAG Question
Yes... but can I RSTP to a bond0 port on the router. that's the question.
-
mhoppes - Associate
- Posts: 664
- Joined: Thu Apr 10, 2014 9:14 pm
- Location: Pennsylvania
- Has thanked: 10 times
- Been thanked: 125 times
Re: LAG Question
Ok.. So confirmed the Edgerouters will do a port bonding with a setting of active-backup. What would be the correct way to configure the switch to handle this setup?
4 posts
Page 1 of 1
Who is online
Users browsing this forum: No registered users and 30 guests