Ugh. I'm finally to that point where we're about out of v4 addresses. I have a direct allocation of v6 (/48) but I'm stuck on what v6 to v4 solution to use or just using Carrier Grade NAT for v4.
Anyone else been down this road already? I'm looking for suggestions and any experiences with different vendors and products. Opinions welcome as well.
I'm also concerned about copyright complains and pinpointing the offender as well.
ipv6 to ipv4
-
LRL - Experienced Member
- Posts: 238
- Joined: Sun Nov 23, 2014 4:00 am
- Location: Rock Springs, WY
- Has thanked: 18 times
- Been thanked: 49 times
ipv6 to ipv4
-LRL
"My reading of history convinces me that most bad government results from too much government." - Thomas Jefferson
"My reading of history convinces me that most bad government results from too much government." - Thomas Jefferson
-
LRL - Experienced Member
- Posts: 238
- Joined: Sun Nov 23, 2014 4:00 am
- Location: Rock Springs, WY
- Has thanked: 18 times
- Been thanked: 49 times
Re: ipv6 to ipv4
Looks like IPv4 brokers are saying about $14 per address to purchase from another holder.
-LRL
"My reading of history convinces me that most bad government results from too much government." - Thomas Jefferson
"My reading of history convinces me that most bad government results from too much government." - Thomas Jefferson
-
rebelwireless - Experienced Member
- Posts: 607
- Joined: Mon Sep 01, 2014 1:46 pm
- Has thanked: 31 times
- Been thanked: 136 times
Re: ipv6 to ipv4
We are CGNATing many IPv4 now. Have a /25 in the NAT pool, has been working quite well. We are using the NAT444 method.
Still offering publics, but getting them to clients via VLAN on the radio and an EoIP tunnel to the core. Then I bridge those with split-horizon to isolate the clients.
Still offering publics, but getting them to clients via VLAN on the radio and an EoIP tunnel to the core. Then I bridge those with split-horizon to isolate the clients.
3 posts
Page 1 of 1
Who is online
Users browsing this forum: No registered users and 12 guests