Page 9 of 12
Re: Firmware Road Map
Posted: Thu Nov 24, 2016 8:29 am
by Ludvik
In version 1.4.5 is improvements: - Show the SFP model number in UI.
It is good. But better is showing all values from DMI enabled SFP modules. As mikrotik (and other manufacturers) does. Wave length parameters, RSSI, serial number, etc.
Re: Firmware Road Map
Posted: Thu Dec 01, 2016 7:39 pm
by bearm
glendale2x wrote:I see SNMP traps been asked for, so I'll throw my hat in and say I'd like to see SNMP traps too. Traps under a single notify object that sends a string of the trap message is fine. You already have an email feature so it might not be that hard to extend that concept to traps.
SNMP write. I really only personally want IF-MIB::ifAdminStatus so ports can be enabled/disabled by a management system. Unless you already have a RESTful interface that can grudgingly live with the extra work that will require since my existing system is built around SNMP-aware devices.
For RADIUS is it possible to have it look for a reply object to limit access to certain users? Something like "NETONIX-Admin = 1" has to be in the reply in order to allow login.
@sirhc:Adding
ifAdminStatus to SNMP would be awesome. +1
I have monitoring that checks Admin and Oper Status that I could make work for Netonix WISP switch if the
ifAdminStatus OIDs existed.
Having SNMP trap support isn't a bad idea either.
Re: Firmware Road Map
Posted: Mon Dec 12, 2016 10:45 pm
by LRL
On the input Voltage, Current and Efficiency it would be handier if the graphs auto scaled based on the max values both low and high. A voltage graph from 0 to 52v makes even a few voltage charge hard to notice.
Re: Firmware Road Map
Posted: Mon Dec 12, 2016 11:14 pm
by sirhc
LRL wrote:On the input Voltage, Current and Efficiency it would be handier if the graphs auto scaled based on the max values both low and high. A voltage graph from 0 to 52v makes even a few voltage charge hard to notice.
Already been requested, in next version.
Re: Firmware Road Map
Posted: Mon Dec 12, 2016 11:49 pm
by LRL
sirhc wrote:Already been requested, in next version.
Cool. Sorry I looked to see if it had but I must have missed it. You've finally done it Chris! I no longer feel the need to install a Mikrotik at all our solar sites to keep track of voltages and automated functions and I recommend your products to all of my peers (well, at least all of the ones I like ;).
Re: Firmware Road Map
Posted: Tue Dec 13, 2016 11:04 am
by bearm
What about ifAdminStatus?
Re: Firmware Road Map
Posted: Tue Dec 13, 2016 12:37 pm
by Eric Stern
bearm wrote:What about ifAdminStatus?
Its on the to-do list.
Re: Firmware Road Map
Posted: Tue Dec 13, 2016 1:02 pm
by bearm
Eric Stern wrote:bearm wrote:What about ifAdminStatus?
Its on the to-do list.
Excellent.
Thank you Eric.
Re: Firmware Road Map
Posted: Wed Dec 28, 2016 4:06 pm
by ste
Please add second gateway. When first gateway is dead use second. Check with ping.
When a backhaul link fails we route through another link. But if the switch has a static gateway it is not reachable and shows dead in monitoring,
Re: Firmware Road Map
Posted: Tue Jan 03, 2017 12:10 pm
by RebusCom
Would it be possible to add IP Alias capability to the GUI for the switch IPv4? This might provide a workaround to STE's issue.